Tyre pressure is the easiest thing to get right on a bike, and one of the most often ignored. The right pressure makes your bike roll faster, grip better and suffer fewer punctures. Here's how to check it and set it properly.
Why tyre pressure matters
Your tyres are the only part of the bike touching the ground. Too little air and the tyre squashes under your weight. The bike feels slow and heavy, steering goes vague, and you risk a "pinch flat", where the tube gets trapped between the rim and a kerb or pothole. Run very low for long enough and you can damage the rim itself.
Too much air causes different problems. The bike feels harsh and skittish, bounces over rough surfaces instead of gripping them, and has less traction on corners, sand and painted road markings.
Tyres also lose air naturally over time, even without a puncture. A bike that hasn't been ridden for a few weeks will almost always need topping up.
Find the right number for your tyre
Every tyre has a recommended pressure range printed or moulded on its sidewall. Look closely around the side of the tyre and you'll find something like "Inflate to 50–85 PSI", sometimes also shown in BAR. This is the most important number in this article. Always stay within the range printed on your tyre, and never go above the maximum.
Some rims, especially on modern road and mountain bikes, also have a maximum pressure. If your rim and tyre disagree, follow the lower of the two limits.
Typical pressure ranges by bike type
These are general ranges to give you a sense of what's normal. Your tyre's sidewall always comes first.
- Road bikes: usually somewhere around 70–100 PSI. Wider modern road tyres often sit towards the lower end.
- Mountain bikes: usually around 20–35 PSI, lower for tubeless setups and soft or sandy ground, higher for hard-packed trails.
- City and hybrid bikes: usually around 40–70 PSI, depending on tyre width.
- E-bikes: varies widely with tyre size. Commuter e-bikes with narrow tyres run higher; fat-tyre e-bikes can run very low. Because e-bikes are heavier, many riders sit in the middle to upper part of the printed range.
- Kids' bikes: usually lower pressures, often roughly 20–40 PSI. Check the sidewall, as small tyres vary a lot.
Fine-tuning within the range
- Heavier riders, or bikes carrying bags or a child seat, generally need more pressure.
- Lighter riders can run lower for more comfort and grip.
- Rough surfaces and sand suit lower pressures; smooth roads suit higher ones.
- Many riders run the rear tyre slightly higher than the front, because more of your weight sits over it.
How to check and set your pressure
- Identify your valve. Presta valves are thin with a small locknut at the tip, common on road and mountain bikes. Schrader valves look like car tyre valves and are common on city bikes, kids' bikes and many e-bikes. Some bikes use Dunlop (Woods) valves. Make sure your pump head fits.
- Remove the valve cap. On a Presta valve, unscrew the small locknut at the top and press it briefly to release a tiny puff of air, which frees it if it's stuck.
- Attach the pump firmly. Push the head on straight and lock the lever if it has one.
- Read the gauge. A floor pump with a built-in gauge is the easiest option. The "thumb squeeze" test isn't reliable; a tyre can feel hard and still be well under pressure.
- Pump to your target. If you overshoot, release a little air and check again.
- Remove the pump cleanly, tighten the Presta locknut and refit the cap to keep sand and dust out of the valve.
Tip: write your chosen front and rear pressures on a piece of tape stuck to your pump. You'll never have to remember or look them up again.
Dubai heat and your tyres
Air expands as it warms. A tyre pumped up in an air-conditioned apartment will read higher once it has been sitting in strong sun, and a bike left in a hot car or on a sunny balcony can see its pressure climb noticeably. Heat also ages rubber faster, so sidewalls can crack sooner than you'd expect.
A few habits help:
- Check pressure before every ride in summer, ideally when the bike is at the temperature you'll be riding in.
- Don't pump right up to the sidewall maximum if the bike is about to sit in the sun.
- Store your bike in the shade, and avoid leaving it in a parked car for long periods.
- Look for small cracks in the sidewall while you're checking pressure.
We cover more summer habits in looking after your bike in Dubai's summer heat.
When a tyre keeps going flat
If a tyre loses pressure overnight or within a day or two, there's a slow puncture, a faulty valve or a damaged rim tape. Look for thorns, glass or sharp stones stuck in the tread before you fit a new tube, or the same object will puncture it again. If the rim itself is dented or cracked, read should you repair or replace your bike wheel?
Checking pressure is also step one of our 2-minute pre-ride safety check.
Let us check it for you
Tyre inspection and pressure adjustment are part of every Bike Buddy service, starting with our Basic package at 150 AED. Our mechanics come to you anywhere in Dubai, look over the tyres for wear and damage, and set the pressure to suit your bike and how you ride. If a tyre or tube needs replacing, we tell you the cost before fitting it. Book a service here.
Let us handle it
Our mechanics come to your home anywhere in Dubai. Bike packages from 150 AED. Book in 60 seconds on WhatsApp.